Commissioning with Terminal PR 5610 Installation Manual
118 Sartorius
5.3 Weighing point mask
Calling up mask
Weighingpoint
is done from the
Main Command Level
by pressing key [W].
PR1713 Rel. 03.12 20.05.2004 09:05
Weighingpoint
Max= 3000kg e= 0001kg
A < > N 0050kg
Max= 3000kg e= 0001kg
B < > N 0330kg
Max= 6000kg e= 0002kg
AB< > N 0380kg
Keys
0 Set Zero I/O Tare In/Out
Select Display T Tare G Gross N Net ? Test F Flow Z Zeroset D Diff S Setp
P Print C Calib/Config A Assign weighingpoints E Exit
♦ The functions of this mask are:
• Weight display and function keys for the weighing points
• Calling up sub-menus/ masks:
calibration / configuration
Calib/Config
weighing point assignment
Assign weighingpoints
♦ Return to the main menu is with [E]
Exit.
♦ Weight display and function keys for the weighing points.
♦ Weighing point selection (A, B or AB) is by means of the cursor up and down keys. The actually selected weighing
point is highlighted by inverse display.
If a physical weighing point has been assigned to e.g. WP B, but does not deliver valid weight data, it is
displayed as follows:
Max= 3000kg e= 0001kg
B Err 9:nocom
⇒ The function keys relate to the instantaneously selected weighing point.
Mask description.
♦ Gross/ net/ tare weight display
G/N/T Select Display
The gross, net or tare weight can be displayed by pressing the relevant key with the scale tared. This is shown by
display of the relevant letter.
♦ Setting the zero is done with key [0]
Set Zero
When the scale was set to zero, >0< is displayed in front of the weight.
♦ Setting or erasing the tare memory is done with keys [I] or [O]
I/O Tare In/Out
♦ Press key [?] to carry out the analog test
? Test
. Test value and reply line
Toggle Testmode Status OK
instead of
the weight is displayed. Pressing key [?] once more displays the previous value again.
♦ Pressing key [P]
Print
prints out the weight values on the printer port.
♦ Calling up mask
Assign weighing points
is done by pressing key [A]. If a production is running, this call is disabled,
message:
Production is active, no configuration possible
To Next Page
Loading...