Sartorius PR 5610 - Plug-In Cards and Modules (Optional)

PR 5610 Installation Manual Function Description
Sartorius 13
2.2.2 Plug-in cards and modules (optional)
On board 1, PR 5610 can accommodate up to 3 cards.
Product Function
PR 1713/04
2 serial interfaces
RS 232 and RS 485/ RS 422.
The RS 485 serial interface must be configured before installation via
DIL switches on the interface card! Protocols configurable by software
set-up.
PR 1713/06 1 Analog output,
galvanically isolated, (only 1 card)
Configuration and adjustment of output levels with software
correction. Signal output analog 16 bits, 20,000 divisions, 0/4 - 20 mA,
0/2...10 V.
PR 1713/07 1 Analog output, 4
analog inputs, (only 1 card)
Output: see PR 1713/06. Input: 4 channels with common ground,
resolution 3,000 divisions.
PR 1713/08 BCD output 5 decades decimal or 3 byte binary (with application program)
PR 1713/12
4 inputs and 4 outputs
Digital interfaces galvanically isolated via optocouplers. Inputs active
or passive. Configurable by software set-up.
PR 1713/13 DIOS master, digital I/O
system for connection of PR 1720 as
2
nd
weighing point and as bus
interface for max. 256 additional dig.
I/O, (only 1 card)
Master function based on Interbus-S standard for control of digital
I/O. A PR 1720 can be used as a 2
nd
weighing point at the DIOS card.
Automatic detection of the connected modules. The max. possible
number of ports is limited to 256 bits or 4 modules. The card has
integrated termination resistors.
PR 1713/15 4 optocoupler inputs
4 relay outputs
similar to PR 1713/12, but configurable relay output.
PR 1713/17
6 inputs and 8 outputs
Digital interfaces galvanically isolated via optocouplers. The input
group has got 1 common minus potential, separated from 1 common
minus potential for the outputs.
The following options can be inserted on board 2:
Product Function
PR 1713/05 RAM extension The memory extension is detected after installation
and cold start.
PR 1713/14 Ethernet Card for 10Mbit/sec network (e.g. with PR 1740)
PR 1721 Field bus interface connecting unit
max. transmission rate 1,5 Mbits
• PR 1721/11 Profibus-DP (slave)
• PR 1721/12 Interbus-S (slave)
• PR 1721/14 DeviceNet (slave)
For details on the products, see chapter 3.4 Options.