Sartorius PR 5610 - Xbpi Scale Parameter Tables

PR 5610 Installation Manual Commissioning
Sartorius 87
4.7.5 xBPI Scale parameter tables
In the following tables the parameters to be entered under [Setup]-[Weighingpoints]-[WP X:xBPIScale]-
[Setup]-[Config]-[Scale], ... [Config]-[Appl] and ... [Config]-[Interf] are listed. Depending on the scale not all
items can be selected. If this is the case, the message
not valid for scale appears.
[Scale]
 Ambient conditions :"
"Very stable cond. "
"Stable conditions "
"Unstable cond. "
"Very unstable cond"
 "Application/Filter :"
"standard mode "
"manual filling "
"automatic dosing "
"checkweighing "
 "Stability range :"
" 0,25 digit"
" 0,5 digit"
" 1 digit"
" 2 digit"
" 4 digit"
" 8 digit"
 "Stability symb.delay:"
"no delay "
"short delay "
"long delay "
"extrem long delay "
 "Tare parameter :"
"at any time "
"not until stable "
 "Auto zero function :"
"Auto Zero on "
"Auto Zero off "
 "Adjustment function :"
"ext.adj.w.fact.wt."
"ext.adj.w.user.wt."
"ext.adj.w.pres.wt."
"internal adjust "
"ext.lin.w.fact.wt."
"ext.lin.w.pres.wt."
"Confirm preload "
"Delete preload "
"adjust disabled "
 "Confirming adjust. :"
"automatically "
"manual "
 "Zero range :"
" 1% of max load "
" 2% of max load "
" 5% of max load "
"10% of max load "
 "Power-On zero range :"
"factory settings "
" 2% of max load "
" 5% of max load "
"10% of max load "
"20% of max load "
 "Power-On tare/zero :"
"activ "
"inactiv "
"only for zeroing "
 "Measure rate :"
"normal output "
"fast output "
 "Calibration check :"
"Off "
"Calibration prompt"
 "External Adjustment :"
"Accessible "
"Blocked "
 "Maximum capacity :"
"reduced by preload"
"constant "