PR 5610 Installation Manual Commissioning
Sartorius 93
Setting the interface parameters [Serial port setup]
Selection of the built-in interface [Builtin RS232], [Slot 1…3
RS485] or [Slot 1…3 RS232] with
or ; confirm [Protocol]
with
.
Protocols available are:
XON/XOFF software handshake
3964R-slv Siemens S5 Dust slave
3964R-mas Siemens S5 Dust master
3964RS5sl Siemens S5 Dust slave with header
3964RS5ms Siemens S5 Dust master with header
EW-COM V1 EW-protocol V1 (standard)*
EW-COM V2 EW-protocol V2 (multiprogram PR 1740)*
EW-COM V3 EW-protocol V3 (DDE server)*
RTS/CTS hardware handshake
JBUS/ModB JBUS / Modbus protocol*
RemoteDsp Remote display string*
W
&M Print W&M printer string*
Modem Modem control
xBPI Additional scale*
* The protocol can be selected only once per instrument. A second selection is not possible, if the protocol has
already been assigned.
Protocol parameters
Select the protocol parameters with or ; confirm with
.
Select baud rate [300, 600, 1200, 2400, 4800, 9600, 19k2, 38k4
and 115k2] with or ; confirm with .
Select bits [7] or [8] with or ; confirm with .
Select parity [None], [Odd] or [Even] with or ; confirm
with
.
Select stop bits [1] or [2] with or ; confirm with .
Select device type [Ansi], [VT52] or [Raw] with
or ;
confirm with
. Ansi and VT52 for VDUs, Raw for printer,
remote display and communication.
Select echo mode [Enabled] or [Disabled] with or ;
confirm with
.
Enter slave address (only for EW protocol A-Z or JBUS/ModBus
protocol 1-127) with or ; confirm with .
After change of at least one parameter safety check. With [YES]
storage of changed data, with [NO] data remain unchanged.
Automatic return to the setup menu for serial interfaces.
To Next Page
Loading...