PR 5610 Installation Manual Commissioning with Terminal
Sartorius 113
The parameters for the serial ports are saved in EAROM.
♦ List of parameters and possible entries (selection):
• Selecting the serial interface: ( Serial IO ): 1, 2, … 7
• Selecting the previous/next serial interface:
Previous / Next serial I/O
• Protocol
: None XON/XOFF, DUST3964R slave, DUST3964R master, DUST3964R S5 slv, DUST3964R S5
mas, EW-COM Slave V1, EW-COM Slave V2, EW-COM Slave V3, RTS/CTS, JBUS/MOD-Bus, Remote
Display, W
&
M Printer, Modem, xBPI
• Number of data bits (
Bits
):
7, 8
• Parity check (
Parity): None, Odd, Even
• Number of stop bits (
Stopbits): 1, 2
• Transfer rate (
Baudrate
):
300, 600, 1200, 2400, 4800, 9600, 19k2, 38k4, 115k2.
• PR 5610 slave address
(Slave-adr): <space>, A to Z
• Terminal type (Devicetyp): Raw, Ansi, VT52
• Echo
(Echo): Disabled, Enabled
If elements appear in brackets on the screen, selection is not possible.
⇒ A PR 5610 can be equipped with max. 7 serial interfaces. For a survey, see chapter 5.2.3.1.
⇒ Dependent of selected protocol (and interface), defined default settings are made by the system.
5.2.3.1 Survey: physical interfaces
The instrument can besides the built-in interface be equipped with max. 6 additional serial interfaces, provided
that the 3 options sockets are fitted with 1713/04. The interface no. is allocated from TTY1 to TTY6 via software.
All interfaces can use each protocol, but EWCOM, Remotedisplay, xBPI and W&M printer only once per
instrument.
The following settings are useful dependent of protocol. These settings can also be changed subsequently.
Protocol Default settings Example Rem.
None
XON/XOFF 8, none, 1, 9600, -, ANSI, enabled System console 1
EWCOM slave V1 7, even, 1, 9600, A EW protocol V1 5, 6
EWCOM slave V2 8, even, 1, 19.2, A EW protocol V2, PR 1740 6
EWCOM slave V3 8, even, 1, 19.2, A EW protocol V3, DDE-server 6, 7
RTS/CTS standard: as XON/XOFF Printer 3
W&M printer 7, even, 1, 9600, -, raw I/O, disabled W&M printer 2
Remotedisplay 7, even, 1, 9600, -, raw-I/O, disabled PR 16xx, remote display 4
xBPI 8, odd, 1, 9600, Sartorius scale
Remarks:
1. A terminal or a PC with a terminal emulation program is used as system console.
2. An FX880/PH02 printer permits W&M weight data print-out.
3. Via this protocol, print-out of all configuration data and weight print-out during weighing point calibration
(if necessary) are made.
4. Thee instrument sends the remote display telegram successively for all 2 weighing point modules. This is
followed by a pause of approx. 80 msec.
Data contents: see PR 1627 and PR 1628 documentation.
5. Protocol for communication with PR 16xx units
6. For operation with PR 1750.
7. For operation with PR 1791 (DDE server).
To Next Page
Loading...