satmap active 20 - Units and Set Speed

Software v3.0.11065
© Satmap Systems Ltd 2017
48
6.17 UnitsandSetSpeed
(GPS MAP → MAIN MENU → Settings → Units and
Set Speed)
This is where you can set your preference for units
of measurement (i.e. for elevation, speeds and
distances), and set your target speed.
Units:Distance&Speed.Use the rocker pad,
moving left/right to switch between Miles and feet,
Kilometres and meters, Nautical Miles and Knots.
Press Done or centre press the rocker pad to return
to SETTINGSMENU.
Target Speed. This is the speed on which
EstimatedTimeofArrival(ETA)
calculations are
based if the average moving speed in the trip
log (Av. Moving) is zero, i.e. you are stationary.
Once you are moving, your ETA is taken from your
average moving speed if you have a lock or recently
had a lock.
Use the rocker pad, moving left/right to select the
Target Speed from 1 kph (0.6 mph) to 100 kph (62.5
mph).
Press Done or centre press the rocker pad to return
to SETTINGS MENU. Pressing the Default button
restores the following settings:
Units: Kilometres and meters
TargetSpeed:10 kph (6.2 mph / 5.4 kn)
6. MAINMENU:SettingsMenu(...cont)
Set desired Units
PressureUnits. Use the rocker pad (L/R) function
to select your desired units for the Pressure display:
Options are :
a. mBar (millibars)
b. inHg (inches mercury)
c. mmHg (mm of mercury)
d. hPa (Hectopascal)