satmap active 20 - Rename LOI; Edit Description; Edit Location by Map

Software v3.0.11065
© Satmap Systems Ltd 2017
87
13. LOIs(LinesofInterest)(...cont)
13.6 RenameLOI
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Rename)
When an LOI is created it is called 'LOI 1' by default
(or similar, depending on the number of existing
OOIs).To rename it, highlight the LOI in the OOI
Folders, press Edit, then Rename. The keypad
appears. Use the rocker pad to rename the LOI.
13.7 EditDescription
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Edit Description)
Highlight EditDescription
, then either press the Edit
button or centre press the rocker pad to access the
keypad (section 9.00).
Operate the keypad to input comments describing
the LOI and press Done when finished. The screen
will return to the EDITLOI menu.
The 'Edit Description' option is only available if the
existing description has 128 characters or less (e.g.
externally imported descriptions from geocaches etc.
with more than 128 characters cannot be edited).
13.8 EditLocationbyMap
(GPS MAP → MAIN MENU → OOI Menu → OOI
Folders → Select LOI → Edit → Edit Location by Map)
You are in edit mode when a red cross appears
inside the orange locator circle. Use the rocker pad
to move the locator circle over individual LOI points
and centre press the rocker pad to select them. A
blue POI icon appears just inside the locator circle
which means you can then drag the LOI point to a
new location. Centre press the rocker pad to confirm
the placement.
If you wish to add another LOI point, press the
'+'
button. To remove an existing LOI point, press the
'x' button.
Press the GPSMap button to return to the last map
screen.
Edit LOI name
Edit LOI
location
POI icon
LOI
LOI
reference
point
(section
16.03)
*