satmap active 20 - Set Trip Data

Software v3.0.11065
© Satmap Systems Ltd 2017
51
6. MAINMENU:SettingsMenu(...cont)
Control Data on
Map Screens
6.20 SetTripData
(GPS MAP → MAIN MENU → Settings → Set Trip
Data)
This is where you can control how inactive routes
are displayed, as well as the deletion/preservation
of trail and trip log data when a new route is
activated.
ShowingInactiveRoutes
• Use the rocker pad, moving left/right to toggle
between;
ShowInactiveRoutes: Inactive routes are shown
on maps.
HideInactiveRoutes: Inactive routes are hidden
on maps.
Show Inactive Routes SP: The start point (SP)
of each inactive route is shown on the maps. (A
gray marker with a black triangle appears at the
start point).
• Press Done or centre press the rocker pad to
return toSETTINGSMENU
.
Note: Showing inactive routes uses a lot of operating
memory on the unit, so it is important to keep this
selection to a minimum, as it will slow down your unit.
Showing too many inactive routes could also 'freeze'
your unit. Only show a few short inactive routes, or to
reduce RAM consumption, choose the ShowInactive
RoutesSP option.
AutoClearTrailData
• Use the rocker pad, moving left/right to toggle
between;
On: Trail data is cleared when a new route is
selected.
Off: Trail data is not cleared on new route
selection.
• Press Done or centre press the rocker pad to
return to SETTINGSMENU.
AutoResetLog
• Use the rocker pad, moving left/right to toggle
between;
KeepLogonNewRoute: Log will not be cleared
when starting a new route.
ClearLogonNewRoute: Log will be cleared on
starting a new route.
• Press Done or centre press the rocker pad to
return to SETTINGSMENU
Pressing the Default button restores the following
settings:
ShowingInactiveRoutes
Show Inactive Routes SP
AutoClearTrailData
Off
AutoResetLog
Keep Log on New Route