2
Safety notes
Preliminary information
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
11
2 Safety notes
2.1 Preliminary information
The following general safety notes have the purpose to avoid injury and damage to
property. They primarily apply to the use of products described in this documentation.
If you use additional components also observe the relevant warning and safety notes.
2.2 Target group
Specialist for
mechanical work
Any mechanical work may only be performed by adequately qualified personnel. Qual-
ified personnel in the context of this documentation are persons familiar with the
design, mechanical installation, troubleshooting and maintenance of the product, who
possess the following qualifications:
• Qualification in the field of mechanics according to applicable national regulation.
• They are familiar with this documentation
Specialist for elec-
trotechnical work
Any electronic work may only be performed by adequately skilled persons (electric-
ally). Qualified electricians in the context of this documentation are persons familiar
with electrical installation, startup, troubleshooting and servicing of the product who
possess the following qualifications:
• Qualification in the field of electrical engineering according to applicable national
regulation.
• They are familiar with this documentation
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives and laws specified
in this documentation. The above mentioned persons must have the authorization ex-
pressly issued by the company to operate, program, configure, label and ground
devices, systems and circuits in accordance with the standards of safety technology.
Instructed persons All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
that the persons are capable of performing the required tasks and work steps in a safe
and correct manner.
2.3 Bus systems
A bus system makes it possible to adapt electronic drive components to the particulars
of the machinery within wide limits. There is a risk that a change of parameters that
cannot be detected externally may result in unexpected (but not uncontrolled) system
behavior and may have a negative impact on operational safety, system availability, or
data security.
Especially in Ethernet-based networked systems and with engineering interfaces,
make sure that unauthorized access is prevented.
Use IT-specific safety standards to increase access protection to the ports. For a port
overview, refer to the respective technical data of the used device.
16998413/EN – 12/2016
To Next Page
Loading...
