SEW-Eurodrive MOVIPRO Ethernet/IP - Example: Delivery Status; Movipro

11
Process data description
MOVIPRO® ADC process sequence
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
126
Digital inputs (2bytes)
Bit Meaning
5 Digital input DI05
6 Digital input DI06
7 Digital input DI07
8 Digital input DI08
9 Digital input DI09
10 Digital input DI10
11 Digital input DI11
12 Digital input DI12
13 Digital input DI13
14 Digital input DI14
15 Digital input DI15
Digital outputs (DO)
Digital outputs (1byte)
Bit Meaning
0 Digital output DO 00
1 Digital output DO 01
2 Digital output DO 02
3 Digital output DO 03
4–15 Reserved = 0
11.3.5 Example: Delivery status
A simple gateway program which supports up to 6 process data for the power section
"PFA-..." is already preinstalled (delivery state) in the communication and control unit
"PFH-..." of MOVIPRO
®
ADC. This allows the drive function of the power section to be
used quickly and easily without additional parameterizations having to be made with
the controller software Application Configurator.
The functionality of MOVIPRO
®
ADC is comparable with a MOVIPRO
®
SDC in this
case. You only have to parameterize the drive functions of the power section to match
your requirements. For further information, refer to chapter "Process image of drive
functions of the power section "PFA-...""(→2133).
In the delivery state, or if no IPOS
PLUS®
application module is loaded, the device con-
tains the process data words of the speed-controlled drive. In the case of the speed-
controlled drive, the device is addressed with 3 process data words.
Fieldbus master
MOVIPRO
®
DO
MOVIPRO
®
control word
PO1
PD numbering
PD assignment
PO2 PO3
DI
MOVIPRO
®
status word
PI1 PI2 PI3
PD2
PD1
PD3 PD4 PD5
Drive function
SEW Controller
18095896715
16998413/EN – 12/2016