SEW-Eurodrive MOVIPRO Ethernet/IP - Deactivating;Activating the DHCP; Address Editor from SEW-EURODRIVE

5
Installation notes
Setting the IP address parameter on the device
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
30
5.2.3 Deactivating/activating the DHCP
You can display and set the type of IP address assignment in the engineering soft-
ware in the parameter tree of the unit in parameter DHCP Startup Control:
• "Stored IP parameters" setting
The stored IP address parameters are used.
• "DHCP" setting
The IP address parameters are requested by a DHCP server.
5.2.4 Address Editor from SEW‑EURODRIVE
In order to access the IP settings of the fieldbus interface of the device, you can use
the Address Editor from SEW‑EURODRIVE.
The Address Editor is installed together with the MOVITOOLS
®
MotionStudio software
package but is used independently. For further information, refer to the description of
the MOVITOOLS
®
MotionStudio engineering software (→2145).
For reliable allocation of the devices displayed in the Address Editor which are con-
nected via X4232_11 and X4232_12 or X4233_11 and X4233_12, a label with the
MAC ID of the device is attached to the housing. For further information, refer to
chapter "Searching Ethernet nodes"(→2146).
Advantages of the Address Editor
The Address Editor provides the following benefits:
• Display and specification of IP settings of all devices from SEW‑EURODRIVE in
one local subnetwork.
• Determination of IP settings for the engineering PC on one system during opera-
tion in order to enable the engineering software to access the device via Ethernet.
• Specification of IP settings for the fieldbus interface of the device, including without
the network connections or Ethernet settings of the engineering PC having to be
modified.
16998413/EN – 12/2016