SEW-Eurodrive MOVIPRO Ethernet/IP - 4 Startup; 4.1 Startup procedure

4
Startup
Startup procedure
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
25
4 Startup
4.1 Startup procedure
The following illustration gives an overview of the startup procedure of the device and
lists other applicable documentation:
1. Device startup
For information, refer to:
• "MOVIPRO
®
SDC Decentralized Drive and Position Controller" operating in-
structions
• "MOVIPRO
®
ADC Decentralized Drive and Application Controller" operating in-
structions
2. Parameterization, Programming
1)
with the MOVITOOLS
®
MotionStudio engineer-
ing software
For information, refer to:
• Chapter "Parameter setting"(→2154)
• "MOVI‑PLC
®
Programming in the PLC Editor" system manual
3. Fieldbus configuration
For information, refer to:
• The chapters "Configuration and startup of EtherNet/IP™" (→ 2 39) and
"Configuration and startup of Modbus/TCP"(→290)
• Chapter "Application modules of the power section "PFA-...""(→220)
• Chapter "Process data description"(→2118)
4. Saving device data to the SD memory card.
For further information, refer to chapter "Storing device data"(→2183).
1) Programming is possible only for MOVIPRO® ADC.
16998413/EN – 12/2016