SEW-Eurodrive MOVIPRO Ethernet/IP - Application Modules for MOVIPRO SDC

3
Introduction
Application modules for MOVIPRO® SDC
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
17
3.5 Application modules for MOVIPRO
®
SDC
Application
modules
for
MOVIPRO®
SDC
In MOVIPRO
®
SDC, the drive data of the power section "PFA-..." are transparently
passed through. You only have to parameterize the desired application module of the
power section to match your requirements.
For further information, refer to chapter "Application modules of the power section
"PFA-...""(→220).
3.6 Application modules for MOVIPRO
®
ADC
Application
modules
for
MOVIPRO®
ADC
3.6.1 MOVIPRO
®
ADC as parameterizable device (CCU)
MOVIPRO
®
ADC includes the Configurable Control Unit (CCU) with standardized and
directly executable application modules you simply need to parameterize. You can ad-
just the functionality of the individual CCU application modules to the specific applica-
tion quickly and without programming knowledge. An integrated diagnostic function
helps to speed up and facilitate startup.
You can parameterize MOVIPRO
®
ADC with the Application Configurator controller
software. The Application Configurator is part of the
MOVITOOLS
®
MotionStudioengineering software.
ApplicationConfigurator controller software
You can use this controller software to select the suitable application module for each
axis of your application (single- or multi-axis application) that runs independently of the
connected drive electronics. The required parameters are entered in the assistant of
the respective CCU application module. Then the entire configuration is transferred to
the parameterizable device.
Application Configurator functions
The Application Configurator controller software provides the following functions:
• Startup and configuration of CCU application modules
• Diagnostics of CCU application modules
Advantages of the Application Configurator
The Application Configurator controller software provides the following advantages:
• The process data monitor visualizes the data exchange between the parameter-
ized CCU application modules and the PLC.
• Data is saved using an SD memory card for the entire CCU application module
and all drive parameters.
• The simulation mode allows for diagnostics of configurations without devices and
motors connected.
• A detailed module diagnostics function allows for simple testing of the CCU applic-
ation module.
• Variables (e.g. travel profiles) are recorded over the time for easy troubleshooting.
• You can simultaneously update the software of the Application Configurator on the
SD memory card when you download the CCU application data.
• The CCU application modules run centrally on the parameterizable device, thus
they are drive-independent.
16998413/EN – 12/2016