13
Parameter setting
Parameterizing the power section "PFA-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
169
13.3.2 Startup the motor
Proceed as follows:
ü The encoder startup is performed (→2159).
1. Select the setting [Download and motor startup] in the startup assistant for en-
coder startup.
ð The startup assistant for motor startup is displayed. Follow the instructions of
the startup assistant. You can switch between the dialogs by using the [Back]
and [Next] buttons.
2. Select the parameter set with which you want to perform the startup.
27021599836096523
3. Select the type of startup:
18587719307
16998413/EN – 12/2016
To Next Page
Loading...
