SEW-Eurodrive MOVIPRO Ethernet/IP - General Error Codes

7
Ethernet Industrial Protocol (EtherNet/IP™)
Return codes for parameterization via "explicit messages"
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
87
7.5.1 General error codes
General
Error Code
hex
Designation Description
00 Success Successful
01 Connection failure A connection-specific service has failed.
02 Resource unavailable The source required for performing the service is unavailable.
03 – Reserved
04 Path segment error
The processing node was unable to interpret the "Path Seg-
ment Identifier" or the segment syntax.
05 Path destination unknown
The "Path" refers to an object class, object instance or a struc-
tural element that is not supported by the processing node.
06–07 – Reserved
08 Service not supported The service is not supported for the selected class/instance.
09 Invalid attribute value Invalid attribute data have been sent.
0A–0B – –
0C Object state conflict
The selected object cannot perform the service in its current
status.
0D – Reserved
0E Attribute not settable It is not possible to access the selected object for writing.
10 Device state conflict
The current status of the device makes it impossible to perform
the required service.
11–12 – Reserved
13 Not enough data
The length of the transferred data is too short for the service to
be performed.
14 Attribute not supported The selected attribute is not supported.
15 Too much data
The length of the transferred data is too long for the service to
be performed.
16 Object does not exist The selected object is not implemented in the device.
17–1D – Reserved
1E Embedded Service Error Internal processing error
1F Vendor-specific error Manufacturer-specific error
20 Invalid parameter
Invalid parameter. This error message is used when a para-
meter does not satisfy the requirements of the specification
and/or the requirements of the application.
21-FF – Reserved
16998413/EN – 12/2016