SEW-Eurodrive MOVIPRO Ethernet/IP - 3 Introduction; 3.1 Content of this documentation; 3.2 Short designation in the documentation; 3.3 Function overview of MOVIPRO SDC and MOVIPRO ADC

3
Introduction
Content of this documentation
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
13
3 Introduction
3.1 Content of this documentation
This documentation describes the operation of the following units on the fieldbus sys-
tem EtherNet/IP™ or Modbus/TCP: MOVIPRO
®
SDC and MOVIPRO® ADC.
3.2 Short designation in the documentation
The following short designations are used in this documentation.
Type designation Short designation
MOVIPRO
®
SDC and MOVIPRO® ADC MOVIPRO
®
Higher-level controller PLC
3.3 Function overview of MOVIPRO
®
SDC and MOVIPRO
®
ADC
Function
overview of
MOVIPRO®
SDC and
MOVIPRO®
ADC
• The MOVIPRO
®
SDC standard inverter with positioning control is equipped with
various basic functions for simple applications.
MOVIPRO
®
SDC enables speed control and precise positioning via simple, free
parameterization without programming and via standardized single-axis modules.
• The MOVIPRO
®
ADC application inverter includes these basic functions, but addi-
tionally offers even more specialized functions for more complex applications.
Depending on the SD card type that is used, MOVIPRO
®
ADC can be used as a:
– Parameterizable device (CCU)
– Programmable device (MOVI‑PLC
®
)
16998413/EN – 12/2016