SEW-Eurodrive MOVIPRO Ethernet/IP - 12.2.4 Configuring devices

12
Operation with the MOVITOOLS
®
MotionStudio engineering software
First steps
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
143
• For functions (online tools) that should directly influence the unit, switch to online
mode by using the icon [1].
• For functions (offline tools) that should directly influence the unit, switch to offline
mode by using the icon [2].
[1] [2]
18014399643939211
2. Select the unit node.
3. Select the tools for configuring the unit from the context menu.
12.2.4 Configuring devices
The following example uses a MOVIFIT
®
device to show how to display the tools for
configuring the device.
The connection mode is "online". The device has been scanned in the network view.
Proceed as follows:
1. Select the device (in this example the power section [1]) in the network view.
2. Right-click to open the context menu.
[1]
9007201701091851
16998413/EN – 12/2016