SEW-Eurodrive MOVIPRO Ethernet/IP - Executing Functions with the Units; Reading or Changing Unit Parameters

12
Operation with the MOVITOOLS
®
MotionStudio engineering software
Executing functions with the units
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
152
12.4 Executing functions with the units
12.4.1 Reading or changing unit parameters
Proceed as follows:
1. Switch to the required view (project view or network view).
2. Select the connection mode:
• If you want to read/change parameters directly on the unit, switch to online mode
by using the icon [1].
• If you want to read/change parameters in the project, switch to offline mode by us-
ing the icon [2].
[1] [2]
18014399643939211
3. Select the unit you want to parameterize.
4. Choose the command [Startup]>[Parameter tree] from the context menu.
ð This opens the "Parameter tree" view on the right section of the screen.
5. Expand the parameter tree to the node you require.
9007200201958155
6. To display a specific group of device parameters, double-click on the group.
7. Press the enter key to finalize any changes you make to numerical values in the
input fields.
INFORMATION
For detailed information about the unit parameters, refer to the parameter list for the
unit.
16998413/EN – 12/2016