SEW-Eurodrive MOVIPRO Ethernet/IP - Page 151

12
Operation with the MOVITOOLS
®
MotionStudio engineering software
Communication via Ethernet
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
151
Communication ports used
The following table shows the communication ports that are used by the
MOVITOOLS
®
MotionStudio engineering software:
Application
Number of the
communication port
Description
ETH server 300 (TCP/UDP)
For the services of the SMLP and
for using a PC as Ethernet gate-
way.
SEW Communication
Server
301 (TCP)
For communication between
MOVITOOLS
®
MotionStudio and
the SEW Communication Server.
Offline data server 302 (TCP)
For communication of
MOVITOOLS
®
MotionStudio in off-
line mode.
MOVIVISION
®
server 303 (TCP)
For communication with a PC with
active MOVIVISION
®
server
Reserved 304 –
TCI server 305 (TCP)
For communication via TCI (Tool
Calling Interface by Siemens)
EcEngineeringServer-
RemoteControl
306 (UDP)
For direct communication (without
master) with the slaves
EcEngineeringServer
mailbox gateway
307 (UDP)
For direct communication (without
master) with the slaves and for
communication via a mailbox gate-
way
MOVI‑PLC
®
visualiza-
tion
308 (TCP/UDP)
For communication between
MOVI‑PLC
®
and the 3D simulation
of MOVITOOLS
®
MotionStudio
16998413/EN – 12/2016