13
Parameter setting
Storing device data
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
183
13.5 Storing device data
The device allows for a quick device replacement. It is equipped with a replaceable
SD memory card on which all device data can be stored. If the device has to be re-
placed, the plant can be started up again quickly by simply exchanging the SD
memory card.
INFORMATION
To be able to replace the device quickly, save the device data to the SD memory
card following successful startup (data management).
INFORMATION
Various parameters change during a reference movement. Carry out a data backup
after a reference movement so that all device data on the SD memory card is current.
Proceed as follows:
1. In the network view of MOVITOOLS
®
MotionStudio, select the communication and
control unit.
2. Choose the menu command [Startup] > [Data management] from the context
menu.
ð Data management is displayed.
18811709451
3. Click on the symbol [1].
ð The following window is displayed.
16998413/EN – 12/2016
To Next Page
Loading...
