SEW-Eurodrive MOVIPRO Ethernet/IP - Page 182

13
Parameter setting
Parameterizing the communication and control unit "PFH-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
182
Create an IEC Project
Proceed as follows:
1. In the network view of MOVITOOLS
®
MotionStudio, select the communication and
control unit "PFH‑...".
2. In the context menu, select the [Programming] >[Create new PLC Editor project]
menu command.
ð The following window is displayed.
9007202821710731
3. Select a project template for controlling the internal power section "PFA‑...".
ð In this example, the project template "Axis_Con-
trol_MOVIPRO_PFA_SingleAxis.pro" [1] is selected.
4. Assign a project name [2] and click [OK] to confirm.
5. Write your IEC program and then load it into the device.
For further information, refer to the following manuals:
• MOVI‑PLC
®
Programming with the PLC Editor
• MOVI‑PLC
®
AxisControl Sample Project
16998413/EN – 12/2016