SEW-Eurodrive MOVIPRO Ethernet/IP - Configuration with Rslogix 5000 up to Version V19

6
Configuration and startup of EtherNet/IP™
Configuration of the EtherNet/IP™ master
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
40
6.2.1 Configuration with RSLogix 5000 up to version V19
The following example describes configuration of the Allen Bradley control ControlLo-
gix 1756_L61 with RSLogix 5000 Version V19.
For the Ethernet communication, a 1756-EN2TR EtherNet/IP™ interface is used.
Proceed as follows:
1. Start RSLogix 5000 and select the view "Controller Organizer" (tree structure on
left part of the window).
2. Select the EtherNet/IP™ interface (1756-EN2TR in this case) in the folder "I/O
configuration".
3. Select the command [New Module] from the context menu.
ð A module catalog is displayed.
16756049803
4. Select "ETHERNET MODULE" in the "Communication" category.
16998413/EN – 12/2016