SEW-Eurodrive MOVIPRO Ethernet/IP - SD Memory Card as Spare Part

14
Service
Device replacement
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
245
14.1.3 SD memory card as spare part
If you have ordered an SD card as spare part, it is possible that the versions of the
bootloader software are different for the SD memory card and your device.
In this case, the device remains in the following state for more than 5 minutes:
7-segment display Status LED S2
8.8.8 flashing Flashing green/orange
Proceed as follows:
1. Disconnect the device from the supply system.
2. Unscrew the memory card cover.
3. Remove the SD memory card.
4. Connect an SD card reader to your PC.
5. Insert the SD memory card in the SD card reader. On your PC, go to [Computer] >
[SD] > [System] > "BootConfig.cfg".
6. Open the file "BootConfig.cfg" with a text editor.
7. Search the file for the following expression:
<!-- Confirm bootloader update with reset button? -->
<ConfirmBlUpdateWithResetBtn>true</ConfirmBlUpdateWithReset-
Btn>
8. Change the value "true" to the value "false" for the parameter.
The expression must now be:
<ConfirmBlUpdateWithResetBtn>false</ConfirmBlUpdateWithReset-
Btn>
9. Save the file.
10. In the status bar, click [Safely remove hardware]. As soon as the PC confirms this,
you can remove the SD memory card from the SD card reader.
11. Insert the SD memory card into the slot of the device and screw the memory card
cover back on.
12. Connect the device to the supply system.
13. Observe the instructions in chapter "Device replacement" (→2 243) from step 8
onwards.
16998413/EN – 12/2016