SEW-Eurodrive MOVIPRO Ethernet/IP - Page 244

14
Service
Device replacement
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
244
The data backup of the communication and control unit is restored.
7-segment display: Status LED S2: flashing green/orange
This can take several minutes.
Do not switch off the device during this process!
The data of the communication and control unit have been restored. Carry out a DC 24 V
reset by switching the device off and back on again.
7-segment display:
Status LED S2: flashing green
Status LED S3: is lit green
Boot sequence is active.
7-segment display:
–
The data backup of the power section is restored.
7-segment display:
Status LED S2: flashing green
Status LED S3: is lit green
7-segment display:
Status LED S2: flashing green
Status LED S3: is lit green
The data backup has been completely restored.
3 seconds
> 5 minutes
Incorrect version of
bootloader software
Chapter
"SD memory card
as spare part"
27021599717141259
• The parameters saved on the SD memory card are now available again. If a differ-
ent parameter set is needed for the new device, change the parameter set now.
Back up the changed data on the SD memory card again after startup.
• For applications with encoders, observe the chapter "Reference travel after device
or encoder replacement"(→2246).
16998413/EN – 12/2016