SEW-Eurodrive MOVIPRO Ethernet/IP - Page 147

12
Operation with the MOVITOOLS
®
MotionStudio engineering software
Communication via Ethernet
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
147
Adjusting the IP address of the Ethernet nodes
Proceed as follows:
1. Start the Address Editor and scan the network.
2. Double-click in the area behind the setting [1] of the Ethernet node you want to
change. You can change the following settings:
• IP address
• Subnet mask
• Standard gateway
• DHCP startup configuration (if supported by the device)
[1]
[2]
18014400041285899
3. Press the enter key to confirm your changes.
4. To transfer the address changes to the Ethernet node, click button [2].
5. For the changed settings to become effective, switch off the device and restart it
afterwards.
16998413/EN – 12/2016