SEW-Eurodrive MOVIPRO Ethernet/IP - Page 161

13
Parameter setting
Parameterizing the power section "PFA-..."
Manual – MOVIPRO
®
with EtherNet/IP™ or Modbus/TCP Fieldbus Interface
161
Setting Description
Edit manually Manual selection and configuration of the encoder.
Detect automatically
Read-out of the connected encoder. The following
encoders from SEW‑EURODRIVE can be read out
only automatically:
• E.7S
• E..H
• A.7W
• A..H
Deselect/select
If there is no encoder connected or if the application
does not require an encoder.
Position detection on/off Specifies the source of the position controller.
16998413/EN – 12/2016