BEFORE
WEIGHING
USING THE
BALANCE
USING MORE CONVENIENTLY MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
143
Continued on next page
3
Change the setting.
Pressing alternately sets the ON and OFF
settings.
[SET]
4
Return to the weighing mode.
*
On setting the GLP output function to ON and outputting weight readings…
A long time is required to output one weight reading.
In addition, when the balance is used in combination with both a PC and printer (option), data may not
be printed correctly at the printer. See the setting conditions below.
Handshake Settings
in the Communication
Settings (
^ page 126)
Rough Time Required for Output of One Weight Reading
Printer Only PC Only
Both Printer and PC used
OFF Approx. 10 sec. Approx. 10 sec. Correct printing is not possible
SW (software) Approx. 33 sec. Approx. 33 sec. Approx. 33 sec.
HW (hardware) Approx. 10 sec. Approx. 10 sec. Correct printing is not possible.
TIM (timer) Approx. 60 sec. Approx. 60 sec. Approx. 60 sec.
*
On setting the GLP output function to ON and using the command code "D01 (continuous
output)"…
No items other than weight readings are output.
! !S!E!T! !
!G!L!P.O!U!T
When ON is set the stability mark is lit.
! !S!E!T! !
!G!L!P.O!U!T
When ON is set the stability mark is lit.
To Next Page
Loading...
