Shimadzu TXB2201L - Minimum Indication

BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
85
*
Calculation formula for the
conversion factor
If we take the conversion factor to be
"k" the formula is as follows.
"k" × value in gram units = balance
weight reading (user-specied units)
5
Return to the weighing mode.
6
Press to call up the user-
specied units.
^
"Switching Units", page 41
Minimum Indication
You can set the minimum weight reading for the user-specied units.
Make the setting by replacing steps 3 and 4 of the conversion factor procedure (^ page 84)
with the following procedure.
3
Select setting of the minimum
indication.
[MIN.D]
4
Enter the minimum indication.
(Enter the smallest indication.) [SET]
^
"Entering Numerical Values", page 49
*
About the minimum weight reading for user-specied units…
This can be set to any required value but in some cases it will not be possible to guarantee the stability
of the weight reading display.

! ! !0.0!0!0
When user-specied units are called up,
no indication of units is given.
! ! !0.0!0!0
When user-specied units are called up,
no indication of units is given.
! ! !M!I!N.D ! ! !M!I!N.D
!0.0!0!1!0!0
! !S!E!T! !
! ! !M!I!N.D
/
/
/
/
/
/
/
/
/
/
/
/
/
/
!0.0!0!1!0!0
! !S!E!T! !
! ! !M!I!N.D
/
/
/
/
/
/
/
/
/
/
/
/
/
/