Shimadzu TXB2201L - Functions Relating to Taring

70
5
FUNCTIONS RELATING TO TARING
The TX/TXB series has the following functions relating to the zero point and taring.
Make use of these functions in accordance with the weighing environment and the application.
Zero / Taring Functions
Zero tracking function
Fluctuations in the zero point that occur
immediately after turning the power ON and as a
result of temperature changes are compensated
for, so the zero indication is maintained.
(^ page 71)
Auto zero function
Drift of the zero point that occurs as a result of
material left on the pan after measurement is
automatically compensated for.
(^ page 72)
Auto tare function
After outputting a weight reading, taring is
executed automatically.
(^ page 74)
Zero / tare timing change function
After waiting for (the stability mark) to light up,
zero point setting / taring is executed.
(^ page 75)
What is taring?
This is a function whereby the weight of the container placed on the pan is subtracted to set the display to zero, so
that only the weight of the sample placed inside the container is indicated.
What is the zero point?
This means the state where nothing is placed on the pan, zero is indicated, and weighing can be started.