Shimadzu TXB2201L - Switching Units

7
 I want to adjust the balance so that it is very accurate
after stabilization.
Span Calibration and Adjustment page 56
 I want to carry out calibration and output a record.
Leaving a Record of Calibration page 67
 I want to check the degree of drift in the balance's sensitivity.
Calibration Check page 60
Calibration
 I want to send data to a PC (e.g. to Excel).
WindowsDirect Communication Function page 111
 After weighing, I want to output automatically upon
stabilization.
Auto Print Function page 106
 I want to output data continuously.
Continuous Output Function page 108
 I want to output data either immediately or after stabilization.
Output Timing Change Function page 129
 I want to change the format of the decimal point
(comma or period) in the output data.
Selecting the Decimal Point Display Symbol page 42
 I want to add the balance model name,
ID and other information to weight readings.
GLP Output Function page 142
Printing /
output
 I want to display weights in units other than g (grams).
Switching Units page 41
Setting the Units page 82
 I want the power to turn off automatically when I am
not using the balance.
Auto Power-Off Function page 138
 I want to go directly into weighing mode when the power is
switched ON.
Setting the Startup Display page 139
Miscellaneous