Shimadzu TXB2201L - Default Chapter; What You Can Do

6
What You Can Do
This section lets you search for a method you would like to try or a function you want to know about.
 I want to weigh up to a xed quantity by adding
increments of the same sample (item to be weighed:
powder, liquid, etc.) a little at a time.
Pouring Mode page 77
 I want to make ne adjustments during weighing,
like increasing the reaction speed of the display or
stabilizing the display.
Easy Setting page 78
 I want to use the balance to count items.
 I want to set unit weights (the weight of a single piece of the
item being weighed) for multiple samples in advance.
Piece Counting page 87
 I want to weigh in percentages.
Percentage Weighing page 92
 I want to weigh a xed amount of each of a number of
different samples (items to be weighed: powder, liquid, etc.)
and to mix these samples according to a formula.
Formulation page 96
 I want to check excess or deciency with respect to a target
value and make "pass or fail" judgments accordingly.
Comparator Function page 102
 I want to adjust the conditions under which the stability mark
lights up.
Adjusting the Stability Mark page 79
 I want to stabilize the display at zero when an empty
sample container is placed on the pan.
Zero Tracking Function page 71
 I want to automatically return the display to zero after
weighing.
Auto Zero Function page 72
 I want to automatically tare the balance (set the display to
zero) after outputting a weight reading.
Auto Tare Function page 74
 I want to tare the balance without waiting for the stability
mark to light up.
Zero / Tare Timing Change Function page 75
Zero point,
and taring
Various
weighing
methods