Shimadzu TXB2201L - Zero; Tare Timing Change Function

BEFORE
WEIGHING
MAINTENANCE
TROUBLESHOOTING
FOR YOUR
INFORMATION
USING THE
BALANCE
USING MORE CONVENIENTLY
75
The zero / tare timing change function allows you to select whether setting of the zero point / taring is
executed without waiting for (the stability mark) to light up, or after waiting for (the stability
mark) to light up after pressing
This function can also be applied to operations under the auto zero function and the auto tare function.
(The default setting is for execution without waiting for (the stability mark) to light up.)
1
Press for about
3 seconds in the weighing mode.
This opens the zero / taring menu.
2
Select the zero / tare timing
change function.
[TARE.F] [SOON]
Stability
Mark
Zero / Tare Timing
Change Function
Lit
The balance doesn't wait for
stability
Unlit
The balance waits for stability.
3
Change the setting.
Pressing alternately selects the "wait for
stability" and "don't wait for stability" settings.
[SET]
4
Return to the weighing mode.
! !T!A!R!E.F
! ! !S!O!O!N
Check the presence or absence of the
stability mark.
! !T!A!R!E.F
! ! !S!O!O!N
Check the presence or absence of the
stability mark.
! !S!E!T! !
! ! !S!O!O!N
When "don't wait for stability" is
selected, the stability mark lights up.
! !S!E!T! !
! ! !S!O!O!N
When "don't wait for stability" is
selected, the stability mark lights up.
Zero / Tare Timing
Change Function