SICK DL100 Pro - Page 71

8024484/2019-06-06 • © SICK AG • Subject to change without notice 71
Operation via Ethernet (Ethernet interface)
“Heater”eld Requirement for display
• Devices with the “heater” option (DL100-xxHxxxxx)
Parameters Description
Switch-on
threshold
Enter power up threshold for the heater.
Read/write access
• Read and write
Input value
• –10 ... +40
Unit
• °C
Factory setting
• –10
Table 48: “Parameter settings” page – “Heater” eld
“Frequencyselection”eld Requirement for display
• Devices with the “frequency selection” option (DL100-xxxBxxxx)
Parameters Description
Switch-on
threshold
Select the frequency range.
Read/write access
• Read and write
Input value
• 0: Mode 1 / 1: Mode 2 / 2: Mode 3
Unit
• °C
Factory setting
• –10
Table 49: “Parameter settings” page – “Frequency selection” eld
“Saveparameters”eld
Parameters Description
Save parame-
ters
Parameterchangeswillonlytakeeectpermanentlyif
they are stored using the “Save” button.
Read/write access
• Write only
Table 50: “Parameter settings” page – “Save parameters” eld
“Reset all parameters to factory
settings”eld
Parameters Description
Reset param-
eter
Clicking on the “Parameter Reset” button resets the parame-
ters to the factory settings.
Read/write access
• Write only
Table 51: “Parameter settings” page – “Reset parameter to default settings” eld