Installation
FLOWSIC600 · Technical Information · 8010125 V 4.0 · © SICK AG 97
Subject to change without notice
4.1.2 Transport and storage
During FLOWSIC600 transport and storage operations, make sure that:
The meter is firmly secured at all times
Measures are taken to avoid mechanical damage
Humidity and ambient temperature are within specified limits (
pg. 209, Table 27).
If the device is to be stored outside for more than one day, sealing surfaces of the flanges
and the interior of the meter body must be protected from corrosion, e.g. with Anticorit
spray (not required for stainless steel meter bodies). The same measure shall be taken if
the meter is to be stored in dry condition, but for more than a week.
Figure 44 Lifting requirements
WARNING:
Only use lifting gear and equipment (e.g. lifting straps) which is suitable for the
weight to be lifted. Max. load information can be found on the type plate of the
lifting gear. It is strongly recommended to use only the eye bolts when lifting
the meter by itself. To lift the FLOWSIC600 please pay attention to
Figure 44.
NOTICE:
Due to natural temperature fluctuation in the course of a day, or if the meter is
transported to a place with different temperature and humidity conditions,
moisture may condense on any material. Carbon steel surfaces may corrode if
left unprotected.
To Next Page
Loading...
Need help?
General
