Commissioning
FLOWSIC600 · Technical Information · 8010125 V 4.0 · © SICK AG 131
Subject to change without notice
5.4 Identification
5.4.1 Checking identification, operation / design data and firmware version
Before commissioning, cross-check the data representing the flow meter with the data in
the test protocols which are contained in the Manufacturer Data Report (MDR). This can be
done on the LCD display (
pg. 221, 9.3) or - much easier - with MEPAFLOW600 CBM soft-
ware:
Open the "Meter information" page and compare the data in the "Identification" section
(
Figure 60) with the data in the check reports of the MDR or, when the meter has been
calibrated, with the calibration and parameter report.
Figure 60 "Meter Information" page
To Next Page
Loading...
