Siemens Cerberus CS1140 - Anschlüsse

E3C010 Battery charging module (superseded by E3C011)
63
Building Technologies 001260_k_en_--.doc
Fire Safety & Security Products 02.2005
11.5 Anschlüsse
Emerg. power
Outputs FAULT
(optocoupler)
max. 1mA/30V
E3C010
1
2
3
4
5
6
7
8
9
10
11
12
+
+
+
+
+
-
-
+
-
13
14
15
16
17
18
19
20
Battery 24V
max. 42Ah,
symmetry monitored
F501
Emerg. power
Power supply
Battery
from converter B2F020
System voltage
Temperature
sensor for battery
C
Inputs FAULT
1
2
3
4
+
+
1
Plug-in terminals
K1
24V
5V
Supply
I-Bus modules
F503
F502
Power supply
Battery
C
12V
12V
Battery (internal)
or 24V external voltage
PTC
to other I-Bus modules
from previous I-Bus modules
for cascading if E3C010 is not connected to the I-Bus
Double flat cable header
ST1
Data communication
I-Bus modules
to other I-Bus modules
from previous I-Bus modules
2)
3)
jumper always required with E3C010
Terminal block
X17
1)
(no 5V output)
GND
-
-
red
green
blue
white
brown
blue
blue
green
red
26 Pin26 Pin
1) PTC is always required including for operation "with external voltage" or "without battery".
2) Function "24 V external voltage" or "without battery" can be programmed via maintenance PC. With the function "external voltage",
battery presence monitoring can be programmed as "active" (i.e. the external voltage is monitored).
3) Remove jumper when using these inputs.