E3M070 Line module ”Interactive” (superseded by E3M071)
82
Building Technologies 001260_k_en_--.doc
Fire Safety & Security Products 02.2005
19 E3M070 Line module ”Interactive” (superseded by E3M071)
19.1 Overview
z Line module for interactive detectors
z I-Bus module with line processor and independent emergency operation proces-
sor
z Designed for 1 loop line or stub line
z With 24 V supply output
z Line inputs and supply outputs protected against over voltage
z Card format 100 mm x 200 mm
z I-Bus address is set at programming switch ”S3”
19.2 Key data
Addresses ...100 1)
Number of wires 2
Twisted cable necessary
Line resistance
...100 Ω
1) 2)
Line capacitance ...300 nF 1) 2)
Short-circuit proof line yes
(line separator in each manual call point and E/A module, automatic
detectors are available with or without line separator)
T-branch yes
Quiescent current at 24 V 215 mA with 100 detectors and supply output unloaded
(135 mA without detector)
Current at supply output ...500 mA / 20...30 VDC (not stabilized)
1) Limitations –> see document 1102
2) with MICC max. 1000 m from the control unit to the last detector, with RADOX
max. 2000 m
Terminal block X20 (20 terminals)
– mounted on module chassis
– for the connection of the prefabricated cable to connection level, or
– for direct connection of the periphery
Card chassis
– mounted on module chassis
To Next Page
Loading...
