B2F020 Converter
70
Building Technologies 001260_k_en_--.doc
Fire Safety & Security Products 02.2005
13.3 Important components
115VAC
230VAC
1
2
3
4
5
6
7
8
Î Check mains voltage setting before commissioning
DANGER
The converter is supplied by the factory at 230 VAC.
To switchover to 115 VAC –> remove metal shield (remove screws ) and then
plug in jumper at the "115 VAC" pin
Legend:
1 Mounting flange
2 Mounting screws for metal shield
3 Clamp to fasten the mains cable
4 Power supply (Mains)
5 unused
6 24 V-Load (24 V)
7 Mounting screws for metal shield
8 Jumper for switchover 115 VAC / 230 VAC
DANGER
To Next Page
Loading...
