B2Q191 Logging printer
244
Building Technologies 001260_k_en_--.doc
Fire Safety & Security Products 02.2005
56.5 Important components
Î Printer B2Q191 fully assembled and pre-wired (view from rear)
1
2
3
4
5
6
8
9
7
Legend:
1 Connection 0-modem (HCMOS level) for ribbon cable «Micro» F20A410 (20-
wire, 1 m) for internal housing connection, for details –> see page 243
2 Connection RS232 / V28 –> see page 247
3 Paper take-up reel –> changing paper see page 248
4 Acknowledge key on front
– Activates the take-up motor for approx. 20 sec.
– Must be pressed after 'Paper fault' and after paper roll has been changed
(only then does the fault signal 'Paper end' disappear)
5 Connection supply 24 VDC
6 Locating frame for printer control card K3L080 and if necessary modem card
To Next Page
Loading...
