E3G060 Control module ”monitored” (Part No 542539)
143
Building Technologies 001260_k_en_--.doc
Fire Safety & Security Products 02.2005
35 E3G060 Control module ”monitored” (Part No 542539)
35.1 Overview
z Control module for monitored alarm devices
z 6 monitored control lines 24 V, 2 A with EMI and over voltage protection
z Individual allocation of control lines via maintenance PC (AlgoWorks)
z It is possible to specify separately whether or not each line must be activated in
”Emergency alarm” mode (programming switch ”S6”)
z Drive horns by internal or external oscillator (intermitted Horn output)
z Max. 8 x E3G060 cards per system (synchronized over plug-in terminal K2)
z Ground fault monitoring, detected via master module E3X10. (for application de-
tails see chapter 6)
z Card format 100 mm x 200 mm
z I-Bus address is set at programming switch ”S3”
35.2 Application
– the E3G060 module is required in systems with more than 2 monitored control
lines for alarm / or similar equipment
– the current on one control line may not exceed 2 A; however, the total current for
all 6 control lines may not exceed 4 A (internal supply K1)
35.3 Key data
Control outputs number
max. load
termination resistor
6
2 A each at 20.. 30 V; total 4 A (internal supply, K1)
2 A each at 24 V
1); total 12 A (external supply, K3)
4.75 kΩ
Quiescent current at 24 V 25 mA (no control line active)
1) Output at same voltage range as from the external supply (K3)
Terminal block X1 (20 terminals)
– mounted on module chassis
– for the connection of the prefabricated cable to connection level, or
– for direct connection of the periphery
Card chassis
– mounted on module chassis
To Next Page
Loading...
