Siemens FS20 - Access Components;Function and Access Type

Planning the networking of the stations
Access components/function and access type
8
101 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
8.3 Access components/function and access type
In addition to operation at the ↑ stations, the fire detection system can be accessed
using the following components:
● SintesoWorks, e.g., to initialize the station, update firmware, upload / download
configuration
● SintesoView
● ↑ Management station via BACnet / Ethernet
The stations can be accessed as follows:
● Local access to ↑ standalone station or ↑ SAFEDLINK station via the station's
Ethernet interface
● Internal access via ↑ GAP station
● Internal access via address: Direct access via the IP address to a station
● External access via GAP or address (remote access)
Select the access type in the 'Connect' window with SintesoWorks.
The management station receives access via the configured network addresses.
Overview of access component/function and access type
Internal access type Remote access (external access)
1
Access component/function Local GAP Address
2
GAP Address
2
SintesoWorks and SintesoView X X X X X
Management station
(BACnet/Ethernet)
– X X X X
Initializing the ↑ station X – – – –
Updating the firmware X – – – –
Uploading / downloading the
configuration via the PC with
SintesoWorks
X X X X X
1
Remote access only via firewall
2
Direct address access is possible and should only be used for special
applications.