Siemens FS20 - Network Module (SAFEDLINK, CC) FN2010-A1; I;O Card (Remote Transmission) FCI2007-A1; Carrier (19, Power Supply) FHA2022-A1

Assembling the FC2080
Basic components of the fire control panel (19", modular) FC2080
12
174 | 242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
12.2.4 Network module (SAFEDLINK, CC) FN2010-A1
The fire control panel FC2080 is networked via FCnet/SAFEDLINK with the
network module (SAFEDLINK, CC) FN2010-A1. The network module
(SAFEDLINK, CC) has a low installation height, so that it can be utilized on the
plug-in cards of the processor unit (19", FC2080) FCC2002-A1.
The following plug-in cards are loaded with a network module (SAFEDLINK, CC)
as standard equipment:
● ↑ CPU card (FC2080) FCC2004-A1
● Communication card (FC2080) FCC2005-A1
12.2.5 I/O card (remote transmission) FCI2007-A1
The I/O card (FUE) FCI2007-A1 provides the remote transmission connections
and the horn outputs. The I/O card (remote transmission) is mainly used in the fire
control panel FC2080 and in the FG2020. However, it can also be used in the
compact control panels FC2030 and FC2060.
The I/O card (RT) has the following features:
● 2 programmable inputs/outputs
● 1 alarm relay and 1 fault relay
● 1 supply output
● Configurable fail-safe and degraded mode behavior
12.2.6 Carrier (19", power supply) FHA2022-A1
The carrier (19", power supply) secures the necessary energy supply in the
FC2080.
The carrier (19", power supply) is comprised of the following elements:
● One carrier plate with DIN rails and cable ducts
● 2 power supplies (150 W), connected in parallel
● One terminal strip for the primary supply
● One terminal strip for the secondary supply
● One free position for a third power supply that can be connected in parallel
(150 W)
The carrier (19", power supply) is mounted on the side wall of the 19" pedestal
housing FH2080-AA.