Siemens FS20 - Determining the Type of Station

Determining the compact station
s
Defining the hardware for the stations
11
162 | 242
Building Technologies
008843_v_en_
--
Fire
Safety
2015
-
12
-
15
11.4.1.2 Defining operating add-ons
The following table is used to select the operating add-on which is installed in the
lower half of the Comfort or Large housing. If using an Eco or Standard housing,
the operating add-on must be fitted in an extra empty housing.
Design Options of the operating unit
Empty operating add-on with cut-out
section for the event printer
FCM2005-A2
● Event printer FTO2001-A1
Operating add-on with 2 LED indicators
(internal) and cut-out section for the
event printer
● FCM2038-A2 (with LED r/g, y)
● Event printer FTO2001-A1
Operating add-on with 4 LED indicators
(internal)
● FCM2036-A2 (with LED r/g, y)
Operating add-on with 20 zones EVAC
[NL]
FCM2008-N1 [NL]
● Event printer FTO2001-A1
Table 45: Operating add-ons and options
If an event printer is also installed in the
operating add
-
on, the dimensions of the
batteries are smaller.
11.4.2 Determining the type of station
Use the following tables to determine the type of the ↑ station.
From MP5, only operating units
which are equipped with the PMI & mainboard
FCM2027 are used.
All ↑ stations with index ES 20 or higher come with the PMI & mainboard
FCM2027 included.
Stations with indexes lower than ES 20 come with the PMI & mainboard
FCM2004 included.
Operating units with the PMI & mainboard FCM2027 are available separately for
converting existing stations. The PMI & mainboard FCM2027 only supports
stations with firmware > MP-EN3.0
You will find detailed information about this in document 008837.
The type designations of the operating units and operating add
-
ons are not order
numbers. They serve as a reference to the previous overview.