Siemens FS20 - Carrier (19, Card Cage) FHA2023-A1; Carrier (19, Option) FHA2024-A1; Card Cage (5 Slots) FCA2008-A1; Battery Tray (19) FHA2021-A1

Assembling the FC2080
Basic components of the fire control panel (19", modular) FC2080
12
175 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
12.2.7 Carrier (19", card cage) FHA2023-A1
The carrier (19", card cage) is a mechanical component that is required in order to
equip the FC2080 with up to two card cages (5 slots) FCA2008-A1 or other
devices.
It is loaded with 2 cable ducts on the side and above.
2 DIN rails 180 mm long are also delivered as accessories.
12.2.8 Carrier (19", option) FHA2024-A1
The carrier (19", options) is a mechanical component that is required in order to
equip the FC2080 with additional options, e.g. relays, sockets or I/O modules.
This component is installed by mounting two DIN rails, 430 mm in length, so that
one is on top of the other.
12.2.9 Card cage (5 slots) FCA2008-A1
The card cage (5 slots) is suitable for holding a maximum of 5 module bus cards
or I/O cards. The card cage is mounted on the carrier (19", card cage) FHA2023-
A1. A maximum of two card cages can be mounted on the carrier.
12.2.10 Battery tray (19") FHA2021-A1
The battery tray (19") FHA2021-A1 is needed for installing and fixing the batteries
in the FC2080 housing (19", pedestal cabinet) FH2080-AA.
A pair of batteries and therefore a battery tray (19") are needed for each carrier
(19", power supply) FHA2022-A1.