Siemens FS20 - 3 Options with Requirements

Options with requirements
3
22 | 242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
3 Options with requirements
You can implement the following options with requirements using the FS20 fire
detection system. The sections specified below are from EN54-2/A1.
EN54-2/A1
section
Options with requirements
7.8 Output to fire alarm devices
7.9.1 Alarm confirmation input from fire alarm routing equipment
7.9.2 Alarm confirmation input from fire alarm routing equipment
7.10.1 Output type A
7.10.2 Output type B
7.10.3 Output type C
7.10.4 Fault monitoring of fire protection equipment
7.11.1 Delays to outputs
7.11.2 Delays to outputs
7.12.1 Type A dependency*
7.12.2 Type B dependency*
7.12.3 Type C dependency
7.13 Alarm counter
8.3 Fault signals from points
8.9 Output to fault warning routing equipment
9.5 Disablement of addressable points
10 Test condition
*For MS9i and collective detector lines only