Siemens FS20 - Analogplus Detector Line; Devices that Can be Connected to the Line Card (Analogplus)

Planning detector lines
AnalogPLUS detector line
7
91 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
7.4 AnalogPLUS detector line
7.4.1 Devices that can be connected to the line
card (AnalogPLUS)
The ↑ line card (AnalogPLUS) FCL2005 is a module bus card which can be used
in fire control panels with a card cage. The purpose of the line card (AnalogPLUS)
is to migrate AnalogPLUS and Synova line devices in the event of modernizations.
The diagram below shows an example overview of the line devices that can be
connected.
Figure 32: Example overview of the line devices that can be connected to the line
card (AnalogPLUS) FCL2005
1) Collective ↑ stub
2) Collective Ex detector line
3) SynoLINE300C
Topologies
The following topologies are possible at the ↑ line card (AnalogPLUS):
● 4 ↑ loops each with a maximum of 128 AnalogPLUS line devices
● 4 stubs each with a maximum of 32 AnalogPLUS line devices
● Mixed variants possible
● Number of devices that can be addressed: max. 512
● Max. loop length 2000 m
Card cage
FCL2005
1)
2)
OP620A
DO113x
AI340
DJ1192
DM113x
DMA1133
MT320A
DC1192
SB3
DO1101-Ex
DT1101-Ex
DF1101-Ex
DC1192 DC1192
1)
DS11
3)
CB320A
OH320C
HI32xC
DOT1131
DT113x
DF1191
DF1192
ABI322A
DC1136
EB322A
DC1131
HI62xC
DC1192
AB322A
OP320A
AI300
OH320AHI32xA