7
90 | 242
The line card (MS9i) is inserted in the card cage of the fire control panel and is
automatically detected by the system.
Topologies
A total of two ↑ loops or one loop and one ↑ stub or two stubs can be connected to
the ↑ line card (MS9i).
The following topologies are possible:
● 2x loops with max. 50 devices each
● 2x stubs with max. 32 devices each
● 1x loop with max. 50 devices and 1x stub with max. 32 devices
Detector systems supported
The ↑ line card (MS9i) is inserted in the card cage FCA2007-A1 or FCA2008-A1
and is automatically detected by the system.
The following devices and detector systems are supported:
● Detector base Z90i, Z94i
● Master base Z90Mi, Z94Mi
● Master element E90Mi (with max. 20 elements)
● Manual call point AT50Mi, AT51Mi, ATAN50Mi
● Control element E90Ci, E90Ci
● Detector D900, D915, D920, F716i, F716Vi F905, F906, F910, F930, R716i,
R930 (F911, F915, F73, R970, AEK1)
● Multimaster card K5M010 (with 4 lines of max. 20 elements each):
– Detectors connected to the multiplexer card must be tested for all functions.
– A slot is not provided in the control panel housing for the multiplexer card. If
space permits, the card can be fitted as required by the customer in the
control panel housing or in an extra housing.
– Multimaster cards inside housings can be powered via the supply output of
the line card FCL2003.
– External multimaster cards must be supplied jointly with an electrically
isolated power supply.
Additional documentation
● You will find detailed information on device compatibility in document 'List of
compatibility'.
● You will find detailed information about the products in the respective Technical
manuals for the devices.
● You will find information about key detector figures in document d825b.
● You will find information about configuration and commissioning in documents
009052 and 009078.
See chapter 'Applicable documents'.
To Next Page
Loading...
