Siemens FS20 - Management Station or Tool in Extended Network

Planning the networking of the stations
Management station or tool in extended network
8
121 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
8.11 Management station or tool in extended network
The ↑ management station must be connected via the Ethernet switch (modular)
FN2012 in the extended network. Any ↑ 'Station' in the FCnet/LAN can be
configured as ↑ GAP. The GAP must be entered as the standard gateway on the
management station.
Figure 53: Tool or management station in extended network
1 FCnet/LAN
2 Ethernet switch (modular) FN2012
3 Ethernet/BACnet
4 Management station or SintesoView, SintesoWorks
5 ↑ Router station and GAP
6 FCnet/SAFEDLINK sub-net
Each ↑ 'Station' in the FCnet/LAN can be configured as GAP.
You will find detailed information on how to enter the required network addresses
in document 009078. See chapter 'Applicable documents'.
1
4
3
5
6
2
2