Siemens FS20 - EVAC-NL Operating Unit FTO2007-N1 [NL]; EVAC-NL Connector Board FTI2002-N1 [NL]; MIMIC Display Driver (EVAC) FT2003-N1 [NL]

Project planning of indication and operation devices
EVAC
-
NL indicators [NL]
5
48 | 242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
5.9.2 EVAC-NL operating unit FTO2007-N1 [NL]
The EVAC-NL operating unit is an evacuation control unit for the Dutch market. It
enables the operation of a maximum of ten evacuation zones.
The EVAC-NL operating unit is connected to the station-internal bus.
The EVAC-NL operating unit is not individually available as an option.
5.9.3 EVAC-NL connector board FTI2002-N1 [NL]
The EVAC-NL connector board FTI2002-N1 is the interface card of the EVAC-NL
operating unit FTO2007-N1 for the serial RS485 module.
The EVAC-NL connector board permits remote operation of an EVAC operating
unit with ten evacuation zones and is also used with the mimic display driver
(EVAC).
5.9.4 Mimic display driver (EVAC) FT2003-N1 [NL]
The EVAC-NL mimic display driver FT2003-N1 is a remote EVAC operating unit
without LED indicator. The EVAC-NL operating unit is mounted on a connector
board that is operated via the RS485 interface.
The EVAC-NL mimic display driver is installed in a separate housing by the
operator and the LED display are arranged according to the layout plan.
Totaal
Al arm
Zoeme
u it
Start
Stop
IN/UIT
LED
TEST
Select
Stop 2x
Sta rt