Siemens FS20 - Connecting SIGMASYS Systems to FS20 [DE, AT]

System overview
Connecting SIGMASYS systems to FS20 [DE, AT]
4
25 |
242
Building Technologies
008843_v_en_
--
Fire Safety
2015
-
12
-
15
4.2 Connecting SIGMASYS systems to FS20 [DE, AT]
You will find the detailed description of FG2020, the specific planning and the
installation in the FG2020, A6V10281424 technical manual.
The FG2020 acts as the connection between the FS20 system, the SIGMASYS
system, or the D100 system and is also a modular fire control panel with
components for detection, evaluation, and alarming in the event of fires.
Figure 2: Principle of FCnet/D100 P system networking
All FS20 'Stations' can be used in the FS20 system.
All SIGMASYS control panels can be used in the SIGMANET system.
D100 control panels and SIGMASYS control panels can be used in the D100
system.
The FG2020 is used for the connection between the systems.
Properties
● Shared operation of D100 control panels, SIGMASYS control panels, and FS20
'Stations' at FS20 'Station'
● Shared ↑ visibility concept
● Uniform global command structure
● Shared message transmission and operation for the fire brigade at the FS20
station:
– RT (fire and fault)
– FBF/FAT
– SD
– External signal transmitters
● Automatic interaction between D100 control panels, SIGMASYS control panels,
and FS20 'Station', i.e., automatic activation of controls in the
SIGMASYS/D100 system based on events in the FS20 system and vice versa.
● Dual CPU operation in FG2020 (optional)
● Optional operating unit in FG2020
FCnet/SAFEDLINK
FG2020
FC20xx
FXS2002
SIGMANET P
FC20xx
SIGMASYS
SIGMASYS
PLAND100
D100
FDnet
SIGMASYS